1. Most take AA cells
Home monitors usually take two AA cells, and some take four AAA. The compartment is on the back or underneath, and the type is printed next to it.
2. Alkaline suits the main unit
The pump and the screen draw more current than a small device, so alkaline cells give the steadiest reading. Rechargeable NiMH cells run flat sooner and can make the monitor show a low battery warning halfway through a measurement.
3. Change them together
Two cells of different ages give a weaker supply, and the monitor may report a low battery or fail mid-test. Fit two new cells of the same type.
4. Sit still and take two readings
Rest for five minutes with the arm at heart level and your feet flat on the floor, and take two readings a minute apart. Write down the second one. A reading taken while talking is not the monitor's fault.
5. The cuff size changes the numbers
A cuff that is too small reads high and one that is too large reads low. If your readings jump around, check the cuff before you blame the batteries.